Electronics Line 3208GLD Manual de usuario descargar pdf (Pagina 34)

254 Event code for user initiated bell cutoff

255 Event code for “E” button

256 Event code for “F” button

257 Event code for “P” button

258 Event code for keypad emergency restore

259 Event code for duress

260 Event code for periodic test Note: This event code is reported with user code 0.

261 Event code for system initialization

ADDRESSES 262 - 295: EVENT ORIENTED EVENT CODE TABLE

The following is a guide to programming event codes.

• 00 - No message is sent for this event.

• 0X (where X is any number between 1 and 9) - A 1 digit event code is sent for this event.

• XX - A 2 digit event code is sent for this event.

• X0 - For opening and closing events, the 0 is replaced with the user number. For zone events, the 0 is

replaced with the zone ID. For system events, such as AC loss, both digits are regarded as the event code.

The following are the addresses for event oriented event code messages. For zone oriented codes refer

to addresses 202 – 261.

262 Event code for zone in alarm

263 Event code for zone alarm restore

264 Event code for zone trouble (battery low)

265 Event code for zone trouble restore (battery low)

266 Event code for zone tamper

267 Event code for zone tamper restore

268 Event code for zone emergency alarm

269 Event code for opening (disarming)

270 Event code for normal closing (arming)

271 Event code for closing with bypassed zones

272 Event code for perimeter closing

273 Event code for LSCP unit tamper

274 Event code for LSCP unit tamper restore

275 Event code for wireless unit supervision failure

276 Event code for wireless unit supervision restore

277 Event code for wireless unit jamming

278 Event code for wireless unit jamming restore

279 Event code for failed to open

280 Event code for failed to close

281 Event code for AC loss

282 Event code for AC restore

283 Event code for low battery

284 Event code for battery restore

285 Event code for manual telephone test

286 Event code for log 75% full

287 Event code for clock change or completion of remote programming

288 Event code for user initiated bell cutoff

289 Event code for “E” button

290 Event code for “F” button

291 Event code for “P” button

292 Event code for keypad emergency restore

293 Event code for duress

294 Event code for periodic test Note: This event code is reported with user code 0.

295 Event code for system initialization

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 50 51

Comentarios a estos manuales

Sin comentarios

Electronics Line 3208GLD Manual de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Electronics Line 3208GLD